Recent content by tas3086

  1. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    I added another drive, but same problem continues. Free space is where logicals were, and are now moved to D:
  2. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    Has any solution or workaround been found to this problem?
  3. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    I removed and reinstalled EaseBCD2.2 . The same problem continues.
  4. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    Additional information: I unplugged all other hard drives, and the problem continues. I usually have 2 arconis selections and am adding a BUI9 selection. I removed the 2 acronis entries, and just went with one the BUI9 entry. (all items except the grub0.mbr entry exist. I also noticed...
  5. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    Yes, local hard drive, 3 bootable partitions, one extended partition with a few logicals. Note that the boot partition that I am using is the third entry in the partition table. (this is a little unusual as I bet most will have 1st entry as the bootable/active entry. I bet your ideas are correct !
  6. T

    EasyBCD 2.2.0.182 creating AutoNeoGrub0.mbr over and over

    I create multiple iso entries that work fine, then after booting I go back and add another entry and it attempts to add the 0.MBR entry again, and all entries in the NST directory are deleted, and only the mbr0 remains. In order to add an entry I have to delete all entries and add them all at...