After following the “Adding Linux to the Vista Bootloader” instructions I am unable to boot from my Linux drives. Grub installed just fine with FC6 and I’m able to boot from Linux (Grub) if I change my BIOS and select that RAID configuration. Vista sees the drive just fine as drive 1 and with two partitions. I have tried drive 1 with partition 1 and drive 1 with partition 2. Nothing happens though just black screen with the cursor flashing in the upper left-hand corner. I do have two RAID 0 configurations, one for Vista and the other for Linux using the Intel ICH8R controller. FC6 sees the RAID configuration just fine and installs with no problem, Again, I am able to boot from Grub when I switch the BIOS to but from that RAID setup. I’ve used BootMagic in the past with this exact configuration and didn’t have a problem, but I don’t know what the problem is in this case besides not selecting the right drive and partition, but again, I have tried all combination that Vista is detecting. Or maybe I need to tell EasyBCD that I have a completely separate drive with a RAID configuration so it can switch control to that drive, I had to do that in BootMagic when using physically separate hard drives. But I just guessing, not sure how EasyBCD handles that. Any help is MUCH appreciated. Thanks in advance.
David
David