Recent content by marky9074

  1. M

    Slackware 12.0 and EasyBCD

    A miracle I think.... I was going away so I just did an install, booted, it worked, so thought :D and did not boot it again. Looking at the 11.0 install it was just using the sata.i image which would not have detected my array either, so I have no idea how I managed to escape toasting my...
  2. M

    Slackware 12.0 and EasyBCD

    OK, I got Gentoo and Ubuntu. Ubuntu did not seem to pick it up, but Gentoo did using dmraid, by invoking the dodmraid ('do' dmraid) There is a how to on the gentoo wiki, which is mostly handraulic, and ideally I want to try and find out how to use dmraid with Slackware.... At this point I...
  3. M

    Slackware 12.0 and EasyBCD

    Yeah, true. Next step is to try and see what Slackware image works (if any)...... Thanks for your help btw. I know it has gone outside the realms of EasyBCD now!
  4. M

    Slackware 12.0 and EasyBCD

    I've tried a few things now to try and get the partitions set up. I usually use Partitionmagic under BartPE, but that failed as well... So I had to install Vista, just to use its partitioning. Then I can restore my ghost backup.... I think I can safely say that it got screwed by the fact...
  5. M

    Slackware 12.0 and EasyBCD

    ahhhh, can I run something past you? I just cleared the MBR as above, and just went to recreate my partitions and notice that it states that my (RAID) disk is 250mb when it's not.....its the size of one of my disks.... Now, when I installed Slackware the other night before I went to sleep...
  6. M

    Slackware 12.0 and EasyBCD

    I have had manic 24hours trying to resolve this. I found out that I had a lot more corruption....not sure what happened initially.. Anyway, I ended up repartitioning and starting again with Vista and Slackware. Same problem, even using V11.0 Tried peeling the bootsector off again, and...
  7. M

    Slackware 12.0 and EasyBCD

    Hi there...first post. I recently installed Slackware 11.0 on a laptop and PC, dual booting with Vista. After realising that Vista now uses the BCD method, started looking around and found this great program.... :D Now all went well on Slackware 11.o using lilo, and today I have just...
Top