EASYBCD DOES NOT START

I

Imlatin

New Member
EASYBCD hasn't started since I did that dual boot, I tried reinstalling it and restarting the PC and opening it as administrator but nothing, it appears in the task manager and disappears again
 
Imlatin said:
EASYBCD hasn't started since I did that dual boot, I tried reinstalling it and restarting the PC and opening it as administrator but nothing, it appears in the task manager and disappears again
Click to expand...
Hello @Imlatin,
Try these steps: krogerfeedback
  1. Run in Compatibility Mode – Right-click EasyBCD, go to Properties > Compatibility, and set it to run as administrator.
  2. Check Dependencies – Ensure .NET Framework and Visual C++ Redistributables are installed.
  3. Verify Boot Configuration – Open Command Prompt (Admin) and run bcdedit /enum to check for errors.
  4. Reinstall Correctly – Uninstall EasyBCD, delete its folder in C:\Program Files, then reinstall.
  5. Use Alternative Boot Manager – If issues persist, consider using Windows Boot Manager or another tool.
You can find more troubleshooting details here.

Best Regards,
James Batson
 
Imlatin said:
EASYBCD hasn't started since I did that dual boot, I tried reinstalling it and restarting the PC and opening it as administrator but nothing, it appears in the task manager and disappears again
Click to expand...
Hello @Imlatin,
Sounds like EasyBCD is crashing on launch—likely due to boot config conflicts from the dual boot setup. Try running bcdedit /enum in Command Prompt to check for errors, and ensure .NET Framework is properly installed. Also, disable any conflicting boot managers and run EasyBCD in compatibility mode.


Best Regards,
Henry Cowan
 
Back
Top