EasyBCD opens to an empty BCD

#1
This PC has 2 HDD with Windows 7 installed on each. The primary system is HDD 0 partition 1.
With the primary system booted:

1. When I start EasyBCD it opens with an empty BCD (no entries).

2. If I use Select BCD Store and try to open the BCD file in C:\Boot I get a message that the file is in use.

3. If I then try Load System BCD I get the BCD that I see when the PC boots.

What is going on and does the result in #1 tell me that the System BCD is in fact the one in C:\Boot?
 

Terry60

Knows where his towel is.
Staff member
#2
Where does Disk Management show the "system" flag ?